Ezi Glide 157

Price: $1,500.00 + GST
For bartercard members
Cash: $1,250.00
Trade: $250.00

 

    Liquid Laminators
             
 
 
 Great for protecting wide format prints
  
 Outdoor signage (vinyls, scrim banner etc)
   
 Fine art prints (water resistant canvas)
   
 Vehicle and boat graphics (vinyls)
   (note: not designed for photographic 
   media or bond papers).
   
 Applies a precise coating that’s 
   always smooth and even.
   
 Saves money by eliminating spray 
   waste and heavy, streaky finishes 
   from hand brushing.
   
 Much faster than spraying, brushing.
   
 Costs less than other coaters and 
   faster than motorized coaters.

   
 Easy to use and easy to clean.

 

 

 

 

 

 
     
 Costs significantly less per
   application than film laminates.
   
 Provides excellent UV, abrasion 
   and water protection.

  
 Enhances the vibrancy of the inks.
 
 Media retains its flexibility.
 
 Will not crack or peel off
 

 
Takes only a minute to set up, seconds to coat and 10 minutes to clean.
   
   
 
Here is how it works:
 
1. Two braces are inserted
     into the back of the
     EZ Glide.
 
 
 
2. The braces then hook onto
     the end of the table to
     secure the applicator,
     making it easily adaptable
     to any size table.
 
 
 
 
3. Pour the coating into the
     back of the tray.
 
 
 
 
4. Swivel up the coating rod
     and place your print over
     the tray, with the first two
     inches extended over the
     front of the tray.
 
 
 
 
5. Swivel down the coating
     rod and the first two inches
     of the print will be submerged
     in the coating. . .
 
 
 
 
     . . . .while the front of the print
     is captured between the
     coating rod on top and the
     silicone squeegee on the
     bottom. Note: this is a special
     wire wound coating rod that
     is used in many applications
     where a precision coating
     is required.
 
 
 
 
6. Pull the print through the
     applicator. The print slides
     through very easily. As it goes
     through, the coating rod wipes
     off the excess coating leaving
     a perfectly smooth coating.
     The red squeegee wipes the
     back of the print completely
     clean (so it will not effect the
     adhesive on pressure
     sensitive vinyls.)
 
 
 
 
7. When finished coating for
     the day, loosen three screws
     and the top half with the
     coating rod comes off easily.
     Cleans with water.

 
 
 
 
8. Use the tube to drain the
     coating back into the bottle
     (takes about 2 ½ minutes
     to drain). Then wash out
     the tray.
 
     
Manufacturer’s Specifications 
Coating Widths
157 cm
Coating Thickness
1/2 mil (dry)
Cost
11 cents per square foot
Dry time   15 to 25 minutes depending on humidity and media type
Finishes   gloss or satin
Coverage
650 square feet per gallon